Simple Mounting Instructions for the Magnet-Ficent Invisible Quilt Hanger 

1. Read application instructions of 3M’s Command Strips™ included in the package instructions.

2. Choose a location that you would like to display a quilt and determine if it is suitable for mounting 3M’s Command Strips™. Determine height and center of desired location and make note of it (pencil mark, wallpaper feature.)

3. Using two 3M’s Command Strips™ mounting strips, apply one to the back of white mounting plate about 2" from each end. Remove red Command™ adhesive liner and firmly press in place on the back of the mounting plate. (Fig. 1)

4. Locate chosen location on wall and firmly attach white metal plate horizontally and centered on noted spot. Press firmly to secure!

5. Install metal rod in rod pocket on quilt, adjust for length (a little shorter is better).

6. Introduce quilt with metal rod installed to black magnets on mounting plate. (Fig. 2)

7. Stand back and look at quilt. If it’s not level, firmly slide one magnet or the other slightly up or down to adjust to level.  ENJOY!

Alternate method of Mounting  (Not as Simple!)

1. The metal plate has holes provided if you wish to install your hanger using screws.  Choose your location and mark the wall through the holes on the mounting plate.

2. Choose appropriate screws for the surface type (drywall, plaster, brick, etc.)  Drill holes, screw plate to wall.

3. Continue with step 5 above.

Fig. 1 

Fig. 2

Simple Mounting Instructions for the Magnetic Invisible Quilt Hanger 5 Piece Kit

1. Read application instructions on 3M’s Command Strips™ included in package.

2.Choose a location that you would like to display a quilt and determine if it is suitable for mounting 3M’s Command Strips™. If mounting surface is not suitable for Command Strips, screws or permanent adhesive can be used (not included).

3. Mark height and center of desired location where quilt is to be displayed. Determine number of plates needed using guide on package back.

4. Use one Command Strip™ per steel plate. Remove red Command™ adhesive liner and firmly press in place on the back of the mounting plate with tab extending from bottom of plate.

5. Locate chosen location on wall and firmly attach desired number of plates, spacing plates equally across the width of the quilt using your previously determined center reference. Plates should be close to same height.

6. Press firmly for 1 minute to secure plates to wall. Wait 1 hour before use.

7. Install steel rod, curtain rod, etc. in rod pocket on quilt, adjust for length.

8. Introduce quilt with steel rod installed to black magnets on mounting plate.

9. Stand back and look at quilt. If it’s not level, firmly slide one magnet or the other slightly up or down to adjust to level.  ENJOY!